Look at the lamp that is currently not working.
Make sure you turn the switch off. This will prevent you from being electrocuted.
If the bulb you are replacing is still working, let it cool down for about 30 seconds or more. If there is no bulb it is ok to skip this step.
Remove the burnt out lamp and dispose of it properly. If you don't have a burnt out bulb to dispose of it is ok to proceed to next step.
Fit the new bulb. Do not over-tighten or press on the bulb too hard.
Turn on the light switch to make sure the bulb works. If light does not work double check to make sure you installed a new bulb. {see prior step}
Make sure you don't get shocked. To do this, turn the switch off before you begin and don't turn it back to on until you're finished.
15,448 Comments - Last post 21 minutes ago by Kyeonu
21 Comments - Last post 1 hour ago by Chris76de
248 Comments - Last post 2 hours ago by quijote3000
46,856 Comments - Last post 5 hours ago by lamusette
458 Comments - Last post 8 hours ago by CBlade
1,441 Comments - Last post 10 hours ago by ekees
56 Comments - Last post 18 hours ago by Gamy7
741 Comments - Last post 12 seconds ago by kungfujoe
133 Comments - Last post 2 minutes ago by ngrazer
85 Comments - Last post 2 minutes ago by kungfujoe
96 Comments - Last post 4 minutes ago by LittleBibo1
524 Comments - Last post 8 minutes ago by CBlade
6 Comments - Last post 21 minutes ago by m0r1arty
874 Comments - Last post 33 minutes ago by Ghoztx9
Comment has been collapsed.
Comment has been collapsed.
Thanks
Comment has been collapsed.
Thanks
Comment has been collapsed.
ty
Comment has been collapsed.
Thanks for the GA and teaching me how to change a light bulb :)
Comment has been collapsed.
thx"!
Comment has been collapsed.
thx
Comment has been collapsed.
Thanks for the info :D
Comment has been collapsed.
Danke :)
Comment has been collapsed.
Thanks!
Comment has been collapsed.
Great giveaway, thanks!
Comment has been collapsed.
ty
Comment has been collapsed.
Thanks!
Comment has been collapsed.
Thank you
Comment has been collapsed.
ty
Comment has been collapsed.
Thank you for the tips, I feel enlightened already!
Comment has been collapsed.
I just removed the bulb from my working lamp ( step 3 ) so I figured that I could just skip step one and two. Didn't turn it off, because that was step 2, and I didn't realize until I was finished already that I was supposed to shut it off ( step 7 where you say to turn it off before you begin ) needless to say it was pretty painful, but I got through it.
Still, good instructions for replacing a non-working light bulb, but you might want to move step 3 up to step 2 and save some others some of the suffering that I went through. Thanks for Fortix.
Comment has been collapsed.
This is the best Skyrim
Comment has been collapsed.
Thanks! :)
Comment has been collapsed.
Thanks!
Comment has been collapsed.
Thanks
Comment has been collapsed.
Thanks for the Fort.
Comment has been collapsed.
thx
Comment has been collapsed.
Thanks
Comment has been collapsed.
thanks!
Comment has been collapsed.