Same rams,did check em on slots 2-4 got 3 errors after 9,5 passes
One ram at slot 2 got 4 errors at 9,5 passes.Will check the other one of the set if its good or not.
Comment has been collapsed.
if your ram craps out after a bios update it's most likely the bios defaulted to wrong values for your ram.
you can use cpu-z to easily check your current settings (speed, timings, voltage) and compare them to the spd / xmp profiles stored on your dimms.
Comment has been collapsed.
It had a small issue then they did cramp after bios update,but immah revert to old bios,change rams and see how it goes
Comment has been collapsed.
175 Comments - Last post 33 seconds ago by DaveQB
5,854 Comments - Last post 5 minutes ago by Axelflox
7 Comments - Last post 8 minutes ago by DaveQB
111 Comments - Last post 40 minutes ago by EaglePB2
40 Comments - Last post 44 minutes ago by EaglePB2
3 Comments - Last post 48 minutes ago by EaglePB2
59 Comments - Last post 3 hours ago by copsofhalo
5 Comments - Last post 8 minutes ago by cynnix
3,533 Comments - Last post 22 minutes ago by Darshao
11,173 Comments - Last post 59 minutes ago by Ifoundadeadrat
9 Comments - Last post 1 hour ago by syclonix
66 Comments - Last post 1 hour ago by BbySu
73 Comments - Last post 1 hour ago by reigifts
126 Comments - Last post 2 hours ago by Wolfgang6688
Hello there.In the past year i've been facing issues with apparently the rams.
I was playing steam games and they were closing like alt+f4.I tried it with WoW aswell installed it in both ssd hdd and after redownload,formats and i was getting errors related either to ram or HDD,SSD.Recently i checked with crystal info and the health of both drives is good.Also i had a blue screen of irql_not_less_or_equal windows 10.
Plus i did update my bios with the @bios application,it only found F13 bios to update,did it and i get a blurry blue screen,and it carries on and loads windows properly.But when i did upgrade bios i got a :Disk error ctrl alt delete to restart.Also i had issues with rams beeping x3 in all slots,also bought different ram but i still had issues.Did try with one ram and i had no problems.I did a memtest x86,after 10 passes it had 3 errors.Also rams are place at slots 2-4 cuz the cpu heater is above 1 and im afraid it will touch the rams.(they arent low profile) Any help there?
Comment has been collapsed.