17 Comments - Last post 55 seconds ago by ViToos
304 Comments - Last post 1 minute ago by VahidSlayerOfAll
578 Comments - Last post 36 minutes ago by UraniumFalconPunch
17,225 Comments - Last post 1 hour ago by yeiro999
564 Comments - Last post 2 hours ago by GinotheMan
8,709 Comments - Last post 2 hours ago by oreomancer
1 Comments - Last post 3 hours ago by Hassat
2,994 Comments - Last post 18 minutes ago by rafalica440
95 Comments - Last post 35 minutes ago by lionheart987
190 Comments - Last post 40 minutes ago by AceBerg42
43 Comments - Last post 43 minutes ago by Masafor
1,713 Comments - Last post 1 hour ago by CLIPPO
7,070 Comments - Last post 1 hour ago by duville
30,662 Comments - Last post 1 hour ago by MarshallBanana0815
Hi guys, I am new in 3D printing. I have Ender 3 V2 with PLA material + Cura slicer. Is here anyone who can help me with good setting of Supports for printing figures? I tried use Tree supports but probably do not have good setting. Thank you for any advise / screenshot which setting you are using.
Thank you
Comment has been collapsed.